EA Spare Parts FAQs
Straight answers to the questions people ask most when finding and fitting spare parts for a fume extraction arm.
Which parts of an extraction arm wear out most often?

The flexible hose is usually the first, as it flexes constantly and can crack, tear or go stiff. Friction plates and washers wear, so the arm stops holding its position. Rubber collars, seals and swivel rings can perish or crack.
Wall brackets and flanges seldom wear but can be damaged by knocks. Check them during your regular inspections.
How do I know the hose needs replacing?

Look for cracks, splits, holes, flattened or collapsed sections, and any place where it has been repaired with tape. A damaged hose leaks, so the arm draws less fume from the weld and more from the surrounding air.
A hose that has stiffened with age or heat can also stop the arm moving smoothly. Replace it rather than patching it, and fit new clamps.
Why does my arm drift or will not stay where I put it?

Arms usually hold their position through friction in the joints. As friction plates and washers wear, a joint loosens and the arm drifts or sags. Replacing the worn parts normally restores it.
Whether a joint can be adjusted, and how, differs between designs, so check the manual for your arm before tightening anything. Do not over-tighten, as that makes the arm hard to position and can damage the joint.
Can I fit these spare parts myself?

Most mechanical spares on an extraction arm are straightforward to fit with basic tools and the manual. Isolate the extraction system first so the fan cannot start, and support the arm so it cannot swing or fall.
Work at height on a bracket or wall mounting needs safe access, and the bracket must be fixed to a surface that can carry the load. If you are not confident, ask a competent person.