0 items in your basket
Total £ 0.00 EX VAT
Mobile Fume Extractors
Extraction Arms & Fans
Plymovent Extraction Fans
Plymovent Hose Tube Arms
Plymovent Metal Tube Arms
Plymovent Plastic Tube Arms
Plymovent Extraction Arm Accessories
Stationary Filter Units
Spark Arrestors
Extraction Tables
Control Equipment
FlexHood
Filters & Spare Parts
Extraction Arm Spare Parts
Stationary Filter Unit Spares
Mobile Filter Unit Spares
Plymovent Fan Spares
Plymovent Extraction Table Spare Parts
Plymovent Filters
Environment Diluter System
Easy Solutions For Source Extraction
Mobile / Portable Solutions
Stationary Solutions
Stationary Solutions with Filter Units
Downdraft Tables
Machine Tool Applications
RPE Air Fed Helmets
Aeroguard Air Quality Monitor
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Straight answers to the questions people ask most when finding and fitting spare parts for a fume extraction arm.
Look for the arm's type label or data plate, which usually gives the model and sometimes the length. Then compare the part with the manual's parts list. Hoses are described by length and diameter, and brackets and flanges by how they connect.Measure the old part if you can, and note the arm's reach and connection size. If you are unsure, send photos and the label details to our team before you buy.
The flexible hose is usually the first, as it flexes constantly and can crack, tear or go stiff. Friction plates and washers wear, so the arm stops holding its position. Rubber collars, seals and swivel rings can perish or crack.Wall brackets and flanges seldom wear but can be damaged by knocks. Check them during your regular inspections.
Look for cracks, splits, holes, flattened or collapsed sections, and any place where it has been repaired with tape. A damaged hose leaks, so the arm draws less fume from the weld and more from the surrounding air.A hose that has stiffened with age or heat can also stop the arm moving smoothly. Replace it rather than patching it, and fit new clamps.
The hose must match the arm's length and the connection diameter, and the clamps must fit that diameter. A hose that is too long can kink or sag, and one that is too short limits reach or pulls on the joints.Check the length of the old hose when it is stretched out to its working position, and measure the diameter of the connection. The manual lists the correct size for your arm.
Arms usually hold their position through friction in the joints. As friction plates and washers wear, a joint loosens and the arm drifts or sags. Replacing the worn parts normally restores it.Whether a joint can be adjusted, and how, differs between designs, so check the manual for your arm before tightening anything. Do not over-tighten, as that makes the arm hard to position and can damage the joint.
Most mechanical spares on an extraction arm are straightforward to fit with basic tools and the manual. Isolate the extraction system first so the fan cannot start, and support the arm so it cannot swing or fall.Work at height on a bracket or wall mounting needs safe access, and the bracket must be fixed to a surface that can carry the load. If you are not confident, ask a competent person.