EA Spare Parts FAQs
Straight answers to the questions people ask most when finding and fitting spare parts for a fume extraction arm.
How do I identify the right spare part for my extraction arm?

Look for the arm's type label or data plate, which usually gives the model and sometimes the length. Then compare the part with the manual's parts list. Hoses are described by length and diameter, and brackets and flanges by how they connect.
Measure the old part if you can, and note the arm's reach and connection size. If you are unsure, send photos and the label details to our team before you buy.
How do I know the hose needs replacing?

Look for cracks, splits, holes, flattened or collapsed sections, and any place where it has been repaired with tape. A damaged hose leaks, so the arm draws less fume from the weld and more from the surrounding air.
A hose that has stiffened with age or heat can also stop the arm moving smoothly. Replace it rather than patching it, and fit new clamps.
What length and diameter hose do I need?

The hose must match the arm's length and the connection diameter, and the clamps must fit that diameter. A hose that is too long can kink or sag, and one that is too short limits reach or pulls on the joints.
Check the length of the old hose when it is stretched out to its working position, and measure the diameter of the connection. The manual lists the correct size for your arm.
Can I fit these spare parts myself?

Most mechanical spares on an extraction arm are straightforward to fit with basic tools and the manual. Isolate the extraction system first so the fan cannot start, and support the arm so it cannot swing or fall.
Work at height on a bracket or wall mounting needs safe access, and the bracket must be fixed to a surface that can carry the load. If you are not confident, ask a competent person.