EA Spare Parts FAQs
Straight answers to the questions people ask most when finding and fitting spare parts for a fume extraction arm.
How do I identify the right spare part for my extraction arm?

Look for the arm's type label or data plate, which usually gives the model and sometimes the length. Then compare the part with the manual's parts list. Hoses are described by length and diameter, and brackets and flanges by how they connect.
Measure the old part if you can, and note the arm's reach and connection size. If you are unsure, send photos and the label details to our team before you buy.
Which parts of an extraction arm wear out most often?

The flexible hose is usually the first, as it flexes constantly and can crack, tear or go stiff. Friction plates and washers wear, so the arm stops holding its position. Rubber collars, seals and swivel rings can perish or crack.
Wall brackets and flanges seldom wear but can be damaged by knocks. Check them during your regular inspections.
How do I know the hose needs replacing?

Look for cracks, splits, holes, flattened or collapsed sections, and any place where it has been repaired with tape. A damaged hose leaks, so the arm draws less fume from the weld and more from the surrounding air.
A hose that has stiffened with age or heat can also stop the arm moving smoothly. Replace it rather than patching it, and fit new clamps.
Can I fit these spare parts myself?

Most mechanical spares on an extraction arm are straightforward to fit with basic tools and the manual. Isolate the extraction system first so the fan cannot start, and support the arm so it cannot swing or fall.
Work at height on a bracket or wall mounting needs safe access, and the bracket must be fixed to a surface that can carry the load. If you are not confident, ask a competent person.