EA Spare Parts FAQs
Straight answers to the questions people ask most when finding and fitting spare parts for a fume extraction arm.
How do I identify the right spare part for my extraction arm?

Look for the arm's type label or data plate, which usually gives the model and sometimes the length. Then compare the part with the manual's parts list. Hoses are described by length and diameter, and brackets and flanges by how they connect.
Measure the old part if you can, and note the arm's reach and connection size. If you are unsure, send photos and the label details to our team before you buy.
What length and diameter hose do I need?

The hose must match the arm's length and the connection diameter, and the clamps must fit that diameter. A hose that is too long can kink or sag, and one that is too short limits reach or pulls on the joints.
Check the length of the old hose when it is stretched out to its working position, and measure the diameter of the connection. The manual lists the correct size for your arm.
Why does my arm drift or will not stay where I put it?

Arms usually hold their position through friction in the joints. As friction plates and washers wear, a joint loosens and the arm drifts or sags. Replacing the worn parts normally restores it.
Whether a joint can be adjusted, and how, differs between designs, so check the manual for your arm before tightening anything. Do not over-tighten, as that makes the arm hard to position and can damage the joint.
Can I fit these spare parts myself?

Most mechanical spares on an extraction arm are straightforward to fit with basic tools and the manual. Isolate the extraction system first so the fan cannot start, and support the arm so it cannot swing or fall.
Work at height on a bracket or wall mounting needs safe access, and the bracket must be fixed to a surface that can carry the load. If you are not confident, ask a competent person.