EA Spare Parts FAQs
Straight answers to the questions people ask most when finding and fitting spare parts for a fume extraction arm.
How do I identify the right spare part for my extraction arm?

Look for the arm's type label or data plate, which usually gives the model and sometimes the length. Then compare the part with the manual's parts list. Hoses are described by length and diameter, and brackets and flanges by how they connect.
Measure the old part if you can, and note the arm's reach and connection size. If you are unsure, send photos and the label details to our team before you buy.
How do I know the hose needs replacing?

Look for cracks, splits, holes, flattened or collapsed sections, and any place where it has been repaired with tape. A damaged hose leaks, so the arm draws less fume from the weld and more from the surrounding air.
A hose that has stiffened with age or heat can also stop the arm moving smoothly. Replace it rather than patching it, and fit new clamps.
What length and diameter hose do I need?

The hose must match the arm's length and the connection diameter, and the clamps must fit that diameter. A hose that is too long can kink or sag, and one that is too short limits reach or pulls on the joints.
Check the length of the old hose when it is stretched out to its working position, and measure the diameter of the connection. The manual lists the correct size for your arm.
Why does my arm drift or will not stay where I put it?

Arms usually hold their position through friction in the joints. As friction plates and washers wear, a joint loosens and the arm drifts or sags. Replacing the worn parts normally restores it.
Whether a joint can be adjusted, and how, differs between designs, so check the manual for your arm before tightening anything. Do not over-tighten, as that makes the arm hard to position and can damage the joint.