0 items in your basket
Total £ 0.00 EX VAT
Mobile Fume Extractors
Extraction Arms & Fans
Plymovent Extraction Fans
Plymovent Hose Tube Arms
Plymovent Metal Tube Arms
Plymovent Plastic Tube Arms
Plymovent Extraction Arm Accessories
Stationary Filter Units
Spark Arrestors
Extraction Tables
Control Equipment
FlexHood
Filters & Spare Parts
Extraction Arm Spare Parts
Stationary Filter Unit Spares
Mobile Filter Unit Spares
Plymovent Fan Spares
Plymovent Extraction Table Spare Parts
Plymovent Filters
Environment Diluter System
Easy Solutions For Source Extraction
Mobile / Portable Solutions
Stationary Solutions
Stationary Solutions with Filter Units
Downdraft Tables
Machine Tool Applications
RPE Air Fed Helmets
Aeroguard Air Quality Monitor
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Practical answers on choosing nozzles, mixers and heating necks, and using and maintaining this style of heavy-duty gas welding and cutting torch.
Yes. HSE guidance says flashback arresters should be fitted to both the oxygen and fuel gas hoses near the regulators, and for long lengths of hose also at the torch. The torch should be fitted with spring-loaded non-return valves.Non-return valves reduce the risk of a flashback but cannot stop one once it has happened, and an arrester is not a substitute for safe working practice. After a flashback, have the torch, hoses, regulators and arresters carefully checked and replace parts where needed. Follow the maker's instructions for checking arresters regularly.
Check connections and equipment regularly. HSE advises a proprietary leak-detecting spray or solution suitable for oxy/fuel systems. Do not use soapy water or anything containing grease or oil on oxygen equipment, and never look for a leak with a naked flame.Repair or replace leaking components straight away. Leaking hoses should not be repaired, but a damaged section can be cut out and the hose tail refitted using crimp clips designed for the job, not screw-tightened clips. Equipment used in harsh conditions will normally need checking more often.
Heating nozzles are used for preheating, straightening, bending and similar work where you want a broad, high heat input rather than a cutting jet. A superheating or heating neck, together with a mixer made for the fuel gas, carries the gas to a larger heating nozzle. Some sizes are designed for acetylene and others for propane.HSE describes copper heating nozzles used with a propane mixer and heating neck, with a typical working distance of around 50 mm for maximum heat input. Always use a nozzle, neck and mixer that are made to work together, and check the maker's instructions.
Generally no. Gas welding of steel is normally done with acetylene. One maker's technical paper explains that burning acetylene in oxygen creates a reducing zone that helps keep the steel surface clean, while propane does not, so propane is usually not suitable for gas welding.Propane is widely used for heating and for cutting with the correct nozzles, and can be used for brazing. If you want to change fuel gas, you will need the mixer and nozzles made for that gas, and regulators and hoses suitable for it. Check the torch manual before changing anything.