0 items in your basket
Total £ 0.00 EX VAT
Mobile Fume Extractors
Extraction Arms & Fans
Plymovent Extraction Fans
Plymovent Hose Tube Arms
Plymovent Metal Tube Arms
Plymovent Plastic Tube Arms
Plymovent Extraction Arm Accessories
Stationary Filter Units
Spark Arrestors
Extraction Tables
Control Equipment
FlexHood
Filters & Spare Parts
Extraction Arm Spare Parts
Stationary Filter Unit Spares
Mobile Filter Unit Spares
Plymovent Fan Spares
Plymovent Extraction Table Spare Parts
Plymovent Filters
Environment Diluter System
Easy Solutions For Source Extraction
Mobile / Portable Solutions
Stationary Solutions
Stationary Solutions with Filter Units
Downdraft Tables
Machine Tool Applications
RPE Air Fed Helmets
Aeroguard Air Quality Monitor
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
DIN 10 90mm x 110mm Filter.
Straight answers on choosing, fitting and looking after the spare parts for a welding helmet with a battery-powered air-purifying blower.
The main items are the particle filters and any pre-filters, the rechargeable battery, the breathing hose, the lenses (the outer cover lens and the filter lens) and the headband and fitting parts. Filters and batteries are the ones replaced most often, which is why HSE advises keeping spare batteries and filters to hand as part of an RPE programme.The blower unit and helmet shell usually last far longer. Check your manual for which parts are intended to be replaced by the user.
Use the manual, the data plate on the blower and the markings on the old part. Helmets, blowers, hoses and filters are normally designed as a matched system, and one set of parts may not suit another even if it looks similar.Note the full part number or marking from the old part and compare it with the new one. Do not rely on size alone. Parts for different helmet versions in the same range can differ, so if you are unsure, our team can help you match the part to your equipment.
Check the battery condition and airflow before every use, as the manufacturer instructs. Trade guidance for powered respirators also suggests checking the airflow level or battery status again during long shifts, for example after four hours and then every two hours, though the interval depends on your manufacturer and risk assessment.If the airflow drops or the low-flow warning sounds, leave the fume area, following your RPE procedure, and change or recharge the battery in clean air. Charge the battery as the maker describes.
Inspect the hose and its connections before each use for cracks, kinks, splits or loose fittings, because a damaged hose can leak air or restrict flow. Keep it away from sparks, spatter and sharp edges, and route it so it does not snag.Wipe it clean as the manufacturer advises, and let it dry before storing it. Do not use solvents unless the manual allows them. Replace a damaged hose rather than repairing it with tape.