0 items in your basket
Total £ 0.00 EX VAT
Mobile Fume Extractors
Extraction Arms & Fans
Plymovent Extraction Fans
Plymovent Hose Tube Arms
Plymovent Metal Tube Arms
Plymovent Plastic Tube Arms
Plymovent Extraction Arm Accessories
Stationary Filter Units
Spark Arrestors
Extraction Tables
Control Equipment
FlexHood
Filters & Spare Parts
Extraction Arm Spare Parts
Stationary Filter Unit Spares
Mobile Filter Unit Spares
Plymovent Fan Spares
Plymovent Extraction Table Spare Parts
Plymovent Filters
Environment Diluter System
Easy Solutions For Source Extraction
Mobile / Portable Solutions
Stationary Solutions
Stationary Solutions with Filter Units
Downdraft Tables
Machine Tool Applications
RPE Air Fed Helmets
Aeroguard Air Quality Monitor
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Spares for a modular MIG welder and its wire feeder and water cooler, and how to match and fit them safely.
Only a competent person should do it. Welding power sources contain mains voltage and, in inverter designs, capacitors that can hold a charge after the machine is switched off. Switch off, disconnect the mains supply and follow the maker's service instructions for waiting and discharging before touching any internal part.Use a qualified electrician for electrical repairs and testing, and never use damaged or faulty equipment. The HSE has also reported a fatal shock where welding equipment was not switched off. The wait time and discharge method depend on the machine, so check the service manual.
Use the data plate on the unit, the service manual and the part number on the old part. A modular MIG system usually has separate power source, wire feeder and cooler units, and each has its own data plate, so note which unit the part belongs to.Record the type, serial number and any version or revision marks. Parts such as circuit cards and casings can look alike across different series and generations but not match, so avoid guessing from looks alone. If the numbers are worn, a photo of the old part and the data plate lets our team help you match it.
Mechanical parts wear far more often than electronics. Worn, wrong-size or badly tensioned drive rolls, a worn or kinked liner and a worn contact tip are frequent causes of erratic feeding, and welding consumable makers advise checking the rolls and tip before the liner, which is more work to replace.If the rolls do not turn at all when the trigger is pulled, look for a fault in the connections, trigger or control leads. Too much roll tension can deform the wire and damage the liner and tip. Only after the mechanical side is ruled out is a feeder card or motor likely to be the cause.
Internal cables and connectors carry control signals and power between cards, so a damaged one can cause intermittent faults that are hard to trace. Look for cracked insulation, bent or burnt pins, loose plugs and signs of overheating.Keep machine terminals and lead connections clean and tight, and never use damaged or faulty equipment. Fit a replacement of the same type and length as the original, seat the connector fully and route the cable away from sharp edges and heat. Disconnect the mains and follow the maker's instructions before opening the unit.