UltraFlex-3 / 4 Spare Parts FAQs
Straight answers to the questions people ask most when choosing and fitting spare parts for a flexible spring-balanced fume extraction arm.
How do I identify the right spare for my extraction arm?
Find the model on the arm's data plate or label, then use the manual's parts list and drawing. Note whether the arm is wall mounted or fitted to a mobile unit, and look at the hose diameter and the number of sections.
Parts for different arm versions can look alike but differ in length, size or fixing. If you are unsure, our team can help you match the part.
Why does my arm sag or fail to hold its position?
Extraction arms are usually balanced by springs or similar counterbalance parts and held in place by friction in the joints. A sagging arm often points to a weakened or broken spring, a loosened joint or worn friction parts.
Check the joint tension first, but only if the manual for your arm allows it. Whether springs should be replaced singly or together depends on how your arm is built, so follow the parts list and instructions for your own model. Support the arm before any work, because springs can hold stored force. If you are unsure, use a competent engineer.
How do I choose between a hood-side part and a wall or unit-side part?
Many spares come in two versions, one for the hood end and one for the wall or unit end, because the loads and fittings differ. Springs, hoses and tubes at the two ends are not usually interchangeable.
Check which end the part belongs to, using the drawing, and make sure it is listed for your arm.
How do I know when to replace the hose pieces?
Replace a hose piece if you see tears, burn marks, collapsed sections, or loose ends. Flexible hoses are often made in pieces for the hood, middle and wall ends, so you only need to replace the damaged one.
Make sure that the replacement has the correct diameter and fittings. A damaged hose cuts suction and lets fume escape.