0 items in your basket
Total £ 0.00 EX VAT
Mobile Fume Extractors
Extraction Arms & Fans
Plymovent Extraction Fans
Plymovent Hose Tube Arms
Plymovent Metal Tube Arms
Plymovent Plastic Tube Arms
Plymovent Extraction Arm Accessories
Stationary Filter Units
Spark Arrestors
Extraction Tables
Control Equipment
FlexHood
Filters & Spare Parts
Extraction Arm Spare Parts
Stationary Filter Unit Spares
Mobile Filter Unit Spares
Plymovent Fan Spares
Plymovent Extraction Table Spare Parts
Plymovent Filters
Environment Diluter System
Easy Solutions For Source Extraction
Mobile / Portable Solutions
Stationary Solutions
Stationary Solutions with Filter Units
Downdraft Tables
Machine Tool Applications
RPE Air Fed Helmets
Aeroguard Air Quality Monitor
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Water cooled 350amp ACHF or DCSP at 100% Duty Cycle, 20.3cm long, 141g. Takes 3 Series Head Consumables. Trim-Line™ torches offer the same current ratings as the standard models they replace while providing a smaller, lighter design.
Answers to common questions about choosing and setting up a complete water-cooled TIG torch package.
A specially treated coolant is recommended instead of tap water, which can cause algae growth or scale (mineral build-up) in the hoses and torch head. Deposits restrict flow, and a torch that is not cooled properly can overheat.Use the type of coolant the cooler maker recommends, keep the level topped up, and clean any filter as instructed. Never run the torch for welding without coolant circulating.
Compare the torch's rated current and duty cycle with the maximum current you will set and how long you weld without a break. Duty cycle is the share of a 10-minute period a torch can run at a given output, and running above the rating can overheat the handle and cable quickly.Makers often give separate DC and AC ratings, and the AC figure is usually lower, so check the one for the current type you use. Read the rating basis on the data sheet and label rather than relying on a single headline figure.
Cooling lets the head and front-end parts such as the collet body and cup run cooler, so consumables typically last longer than on torches that rely on air alone. That means fewer changeovers during a long job.Consumables still wear. Worn collets, damaged O-rings and cracked cups should be replaced, and tungsten should be matched to the collet size. If you change the tungsten or cup, switch off the welder first.
Welding torches are covered by an international safety standard for torches, which applies to manual, air-cooled and liquid-cooled types and sets out construction and test requirements such as heating and insulation tests. Ask for the maker's statement of conformity if you need to show what a torch is built to.A standard does not replace the data plate. Use the torch only within the ratings on its label and in its manual, and check it for damage before each shift.