0 items in your basket
Total £ 0.00 EX VAT
Mobile Fume Extractors
Extraction Arms & Fans
Plymovent Extraction Fans
Plymovent Hose Tube Arms
Plymovent Metal Tube Arms
Plymovent Plastic Tube Arms
Plymovent Extraction Arm Accessories
Stationary Filter Units
Spark Arrestors
Extraction Tables
Control Equipment
FlexHood
Filters & Spare Parts
Extraction Arm Spare Parts
Stationary Filter Unit Spares
Mobile Filter Unit Spares
Plymovent Fan Spares
Plymovent Extraction Table Spare Parts
Plymovent Filters
Environment Diluter System
Easy Solutions For Source Extraction
Mobile / Portable Solutions
Stationary Solutions
Stationary Solutions with Filter Units
Downdraft Tables
Machine Tool Applications
RPE Air Fed Helmets
Aeroguard Air Quality Monitor
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Guidance on choosing, setting up and looking after the drive rollers and torch parts used on a MIG wire feed system.
The groove shape has to suit the wire. A smooth V-groove is normally used for hard solid wires such as mild and stainless steel. Flux-cored wire is hollow, so it generally needs a knurled (toothed) V-groove or similar profile that grips without crushing the core. Soft aluminium wire needs a smooth U-groove so the wire is supported rather than squashed.A cogged U-groove is also used for very soft cored wires. If you are unsure, check the wire maker's recommendation and the feeder manual before ordering.
Use the setting in the machine manual or the wire maker's advice if there is one. If not, release the tension, then tighten it gradually until the wire feeds steadily, and no more. Too little tension lets the wire slip, while too much can squash or deform the wire and lead to jams or bird-nesting.A common check is to feed the wire against a gloved hand or a non-conductive surface at the torch end, with the torch pointed away from you and the manual's safe-feeding method followed. The wire should push out steadily, and the rollers should slip rather than the wire buckling if it is held. Never grip live wire bare-handed or put fingers near the rollers. Reset the tension each time you change the rollers or wire type.
Flux-cored wire has a hollow tube filled with flux, so it can be flattened or deformed more easily than solid wire. Raising the pressure to cure a feeding problem can push teeth from knurled rollers into the wire, and those marks then wear the liner, guide tubes and contact tip.Rather than adding pressure, check that you have the correct knurled roller for the wire, that the groove size is right, and that the liner and tip are in good condition. Use the lowest pressure that feeds smoothly.
Signs include the wire slipping even when the tension is correct, uneven or jerky feeding, shavings or dust building up around the feeder, and a groove that looks widened, flattened or has lost its sharp teeth (on a knurled roller). Knurled rollers tend to wear faster than smooth ones.It is good practice to look at the rollers each time a new spool is fitted. When a roller is replaced, check the guide tubes and liner too, as a worn guide tube can bring back the same feed resistance.