0 items in your basket
Total £ 0.00 EX VAT
Mobile Fume Extractors
Extraction Arms & Fans
Plymovent Extraction Fans
Plymovent Hose Tube Arms
Plymovent Metal Tube Arms
Plymovent Plastic Tube Arms
Plymovent Extraction Arm Accessories
Stationary Filter Units
Spark Arrestors
Extraction Tables
Control Equipment
FlexHood
Filters & Spare Parts
Extraction Arm Spare Parts
Stationary Filter Unit Spares
Mobile Filter Unit Spares
Plymovent Fan Spares
Plymovent Extraction Table Spare Parts
Plymovent Filters
Environment Diluter System
Easy Solutions For Source Extraction
Mobile / Portable Solutions
Stationary Solutions
Stationary Solutions with Filter Units
Downdraft Tables
Machine Tool Applications
RPE Air Fed Helmets
Aeroguard Air Quality Monitor
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Straight answers on choosing, setting up and troubleshooting self-shielded gasless flux-cored wire.
Gasless (self-shielded) wire is a hollow tube filled with flux. When the arc melts the wire, the flux burns to make a shielding gas around the weld pool and also forms a layer of slag over the finished weld. That is why no bottle, regulator or hose is needed.The trade-offs are that the slag has to be chipped off, the bead usually looks rougher than a gas-shielded MIG weld, and there is generally more smoke and spatter. Many people accept this for the portability and the ability to weld outdoors.
It is a public classification that describes the wire. In general terms the E means an electrode, the 7 relates to its tensile strength class, the 1 means it can be used in all positions, the T means it is a tubular (flux-cored) wire, and the last number describes the type of flux and the shielding and polarity it is designed for. An -11 wire is typically self-shielded and run on electrode negative.Check the standard or the maker's data sheet for the full detail, and use the classification to compare wires from different makers rather than relying on the product name.
Stickout is the length of wire between the contact tip and the work. Gasless wire normally runs with a longer stickout than solid MIG wire; around twice as long is a common rule of thumb. A longer stickout preheats the wire and keeps the flux working properly.Too long a stickout causes porosity, an unstable arc and burnback to the tip, while too short gives excessive spatter and overheats the tip. Follow the wire's data sheet for the right range and adjust in small steps.
Flux-cored wire is a soft tube, so it can be squashed by too much pressure. Knurled (grooved) drive rolls grip it well without crushing it, whereas the smooth V-groove rolls used for solid steel wire may slip.Set the drive roll tension just high enough to feed the wire without slipping, as set out in the machine manual. A crushed or flattened wire shows as erratic feeding and a rough arc. Match the roll groove to the wire diameter.