0 items in your basket
Total £ 0.00 EX VAT
Mobile Fume Extractors
Extraction Arms & Fans
Plymovent Extraction Fans
Plymovent Hose Tube Arms
Plymovent Metal Tube Arms
Plymovent Plastic Tube Arms
Plymovent Extraction Arm Accessories
Stationary Filter Units
Spark Arrestors
Extraction Tables
Control Equipment
FlexHood
Filters & Spare Parts
Extraction Arm Spare Parts
Stationary Filter Unit Spares
Mobile Filter Unit Spares
Plymovent Fan Spares
Plymovent Extraction Table Spare Parts
Plymovent Filters
Environment Diluter System
Easy Solutions For Source Extraction
Mobile / Portable Solutions
Stationary Solutions
Stationary Solutions with Filter Units
Downdraft Tables
Machine Tool Applications
RPE Air Fed Helmets
Aeroguard Air Quality Monitor
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Straight answers to the questions people ask most when choosing and using MIG welding accessories and consumables.
Beyond the welder and torch, a few small items make a real difference: a pair of MIG pliers for cutting wire and removing nozzles and tips, a tool for cleaning spatter from the nozzle, anti-spatter, a torch stand, a gas flow tester, and spare tips and nozzles.Depending on your work you may also want wire lubricant pads, a spool adaptor, and a gas heater for carbon dioxide. None of them is essential on day one, but each saves time or prevents a common problem, so build up the kit as you find out what your work needs.
Some accessory makers sell felt-type pads that fit over the wire as it leaves the spool and hold a lubricant. The idea is to reduce friction in the liner and to wipe loose dirt from the wire before it reaches the tip.They are not essential on every machine, and many feeding problems are cured by a clean liner of the right type, the correct drive rolls, a tip that matches the wire and the right roll pressure. Any lubricant on the wire must be one that the wire or machine maker approves for that wire, because the wrong one can cause contamination and weld defects. Check the manual for your own machine before fitting a pad.
When carbon dioxide leaves the cylinder it expands and gets very cold, and at high flow rates or in long periods of welding this can freeze the regulator and reduce or stop the gas. A heater fitted between the cylinder and the regulator warms the gas and prevents this.It is mainly needed when welding with pure carbon dioxide at higher flows or for long stretches. For argon mixtures at normal flows it is not usually needed. Heaters run from an electrical supply, so follow the maker's instructions and keep them away from water.
Small cylinders are handy for occasional light jobs because they are light and easy to store, but the gas does not last long, so they are not suited to regular or heavy welding. How long one lasts depends on the flow rate and how much you actually weld.If you weld often, a larger refillable cylinder is usually more practical. Small cylinders need a regulator and, in some cases, an adaptor made for them, so check what fits. Never refill or tamper with a disposable cylinder.