0 items in your basket
Total £ 0.00 EX VAT
Mobile Fume Extractors
Extraction Arms & Fans
Plymovent Extraction Fans
Plymovent Hose Tube Arms
Plymovent Metal Tube Arms
Plymovent Plastic Tube Arms
Plymovent Extraction Arm Accessories
Stationary Filter Units
Spark Arrestors
Extraction Tables
Control Equipment
FlexHood
Filters & Spare Parts
Extraction Arm Spare Parts
Stationary Filter Unit Spares
Mobile Filter Unit Spares
Plymovent Fan Spares
Plymovent Extraction Table Spare Parts
Plymovent Filters
Environment Diluter System
Easy Solutions For Source Extraction
Mobile / Portable Solutions
Stationary Solutions
Stationary Solutions with Filter Units
Downdraft Tables
Machine Tool Applications
RPE Air Fed Helmets
Aeroguard Air Quality Monitor
Shop 55,000 Products
SERVICEDEPT.
RAPID BLOG
FEEDBACK
HIRE
Straight answers to the questions people ask most when choosing, fitting and looking after a MIG torch tip holder.
The tip holder screws onto the torch neck and the contact tip screws into it. It holds the tip in the right place at the front of the torch and carries the welding current through to the tip, so the wire picks up current as it leaves the torch.On many torches it is a replaceable part, so the wear caused by repeated tip changes falls on the holder rather than the neck. Because it sits right at the front, it sees a lot of heat and spatter, so it is a normal wearing part.
Not always. On many torches the tip holder and the gas diffuser are two separate parts: the holder takes the contact tip and the diffuser, which has small gas holes, spreads the shielding gas evenly round the inside of the nozzle. On some torch designs one part does both jobs, and different makers use the words holder, adaptor and diffuser in different ways.So do not rely on the name alone. Check your torch type and the parts list in the torch manual, or compare the old part with the new one before fitting.
Some torches have an exchangeable holder and some have the holder fixed into the neck. A fixed holder usually passes heat away better, but each tip change wears its thread and it cannot be replaced on its own. If that thread fails, the whole neck may need to be changed.An exchangeable holder lets you replace just the worn part. Which type you can fit depends on your torch design, so check the manual before ordering rather than assuming the two are swappable.
Replace it if the thread is worn or stripped so the tip will not seat firmly, if the tip keeps working loose, if the holder is cracked, burnt or discoloured, or if spatter in the bore or gas holes cannot be cleared. A loose or worn joint is a common reason for contact tips overheating and wearing quickly.There is no fixed time interval. Makers generally advise replacing parts when you can see wear or damage rather than on a schedule. Check the holder and bore for spatter during routine torch checks.